|Nominal Voltage||12V||Capacity||C20||212Ah (10.5V, at 25℃)|
|Nominal Capacity (C10)||200Ah (10.5V,at 25℃)||C10||200Ah (10.5V, at 25℃)|
|Dimension||Length 522mm||C5||175Ah (10.5V, at 25℃)|
|Width 240mm||C1||130Ah (9.6V, at 25℃)|
|Height 218mm||Internal Resistance||Approx. 3.4 mΩ (25℃)|
|Total Height 223mm||Max Short-duration Discharge Current||3000A(25℃)|
Sealed and maintenance free, safety, no leakage
ABS containers and covers optional
Safty valve installation of explosion proof
High quality and reliability
Exceptional deep discharge recovery
Flexible design for multiple installation
Wide operating temp. range
High capability, high energy density
More deep cycle times
Long service life, Excellent recharge and discharge performance
Sealed and maintenance free operation.
Non-Spillable construction design.
ABS containers and covers optional.
Safety valve installation for explosion proof .
High quality and high reliability.
Exceptional deep discharge recovery performance.
Low self discharge characteristic.
Flexibility design for multiple install positions.
The maximum design life up to 15 years
Long time discharge
Suitable for space and storage electric power use
Special plate design, long cycle lifetime
Using special lead-calcium alloy to boost up the grid
anti-corrosive performance and extend the battery using lifetime
Using special separator to boost up the battery performance inside
High thermal capacity, reduce the risk of thermal out of control
and drying hard, can be used in bad environment
High gas recombined reaction efficiency
Little water losing, no electrolyte stratification phenomenon
Long storage time
Good deep discharge resilience performance
Using gas silicon dioxide, small granule degree, bigger than
Stand By applications
Medical equipments (stationary and portable i.e. X- ray)
Computer back-up (high power)
Fire alarm systems
Cash register systems
Emergency lights signal systems
Elevators emergency power supply (skyscrapers)
Airport / runway emergency illumination
Emergency power supply for hospitals
Radar and satellite stations
Solar and wind mill units
Flash units also for mining (head flash)
Boats or buoys
Toys and hobby applications
Portable equipments for communication
testing, distance measuring …etc.
The unique construction and sealing techniques ensure no
from case or terminals.
Electrolyte Suspension System
All batteries utilize an electrolyte suspension system consisting
of a high
porosity, glass fiber material which in conjunction with plates,
totally absorb and
contain the electrolyte.
CGB batteries incorporate a built-in design that controls gas
induces recombination of more than 99% of gases generated during
Maintenance Free Operation
There is no need to check specific gravity of the electrolyte or
add water to
batteries during float service life. In fact, there is no provision
for this type of
Low Pressure Valve Regulated System..
All batteries are equipped with safety release valves, designed to
between 1.5 and 6 psi (10-40kPa) and automatically reseal. Hence,
never an excessive accumulation of gas within the battery.
Heavy Duty Grids
Heavy duty lead calcium tin alloy grids provide an extra margin of
and service life in either float or cyclic applications.
Cyclic Service Life
More than 600 discharge/recharge cycles can be realized from CGB CB
batteries, dependent on the average depth of discharge.
Float Service Life
Self Discharge - Shelf Life
The self discharge rate at room temperature is approximately 3% of
capacity per month.
JP Batteries may be operated over a broad range of ambient
The batteries are manufactured using a range of terminals which
vary in size
and type. Please refer to details as shown
Don’t near the hot source and don’t under the sunshine.
Don’t charge in the sealed container.
No short circuit. It should be addition charge if you don’t use,
and single charge
per three months, to avoid irreversible sulfating. The battery
should be changed
when the battery jar broken or the electrolyte omitted, to avoid
Don’t store in the space of acid gas.
You should be careful and regular check when use the battery. To
battery don’t work. You should change the battery if the capacity
is not full or has
been damage, especially after one year using.
Don’t put the battery in the fire, or it will explode.
Please use cotton cloth to clean, if the battery is broken down and
electrolyte. Please wash your skin when touch the electrolyte.
Don’t clean the battery by using the organic solution. (e.g.
ging time: 15~20h; Temperature compensation coefficient: